ENGINE (J05E)/TROUBLESHOOTING2–584
INSPECTION PROCEDURE: P0521
1. Check the oil level gauge and make sure the engine oil quantity is
within the stipulated value.
2. Check the engine oil condition (dirt, viscosity).
1. Make sure there is no oil leaking from the engine unit or from
around the oil pressure switch.
1
Check the engine oil level
Oil level gauge
FULL
ADD
Engine damage will occur.
Gauge end
Rivet
Preferred level
Was any failure found?
Adjust the engine oil quantity so that it is
within the stipulated value.
Change the oil if it is dirty.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Check for engine oil leaks
Was any failure found?
Repair the faulty part.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
To Next Page
Loading...
Need help?
General
