ENGINE (J05E)/TROUBLESHOOTING2–628
INSPECTION PROCEDURE: P0610
1. Set the starter key to the "LOCK" position.
2. Connect the vehicle to HINO DX Ⅱ .
3. Set the starter key to the "ON" position.
4. Select [Engine] and check if any DTC other than P0610 (for exam-
ple, U1001, U110A) has been detected.
1. Select [VCS] and read the vehicle information (VIN) written in the
Vehicle control ECU at system fix.
2. Compare the data with the vehicle's VIN LABEL, and check if the
vehicle information (VIN) that has been written to the Vehicle con-
trol ECU is correct.
1
Check the DTC detected 1 (Engine ECU)
Has a DTC other than P0610 been detected?
Go to the diagnostic procedure of a related
DTC.
Go to step 2.
2
Inspect the vehicle Information [HINO DX Ⅱ ]
Is the vehicle Information (VIN) in the vehicle control ECU correct?
Go to step 4. Go to step 3.
To Next Page
Loading...
Need help?
General
