ENGINE (J05E)/TROUBLESHOOTING 2–439
1. Set the starter key to the "ON" position.
2. Use the electrical tester to measure the voltage between the termi-
nals of the engine speed main sensor (crankshaft position sensor)
vehicle side connector.
4
Inspect the engine speed main sensor (crankshaft position sensor) power supply
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
Engine speed
main sensor
(crankshaft posi-
tion sensor) vehi-
cle side connector
NE+ – NE-
4.5 – 5.5 V
Do the measurements meet the standard value?
Go to step 7. Go to step 5.
To Next Page
Loading...
Need help?
General
