ENGINE (J05E)/TROUBLESHOOTING2–110
INSPECTION PROCEDURE: P0006 and P0007
1. Check the connection of the fuel cut valve connector (looseness
and poor contact).
1. Check the installation of the fuel cut valve.
1
Inspect the fuel cut valve connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect the fuel cut valve
Was any failure found?
Install the fuel cut valve correctly.
Replace the fuel cut valve if it is damaged.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
To Next Page
Loading...
Need help?
General
