ENGINE (J05E)/TROUBLESHOOTING2–604
DTC: P054F
EN01H02127030602016095
P054F: Idling injection rate abnormality (High)
INFORMATION
1. Technical description
• The engine ECU detects that engine injection rate is abnormally high during idling.
<Description of malfunction>
• Abnormally high engine injection rate is detected during idling.
2. DTC set condition
(1) DTC detection condition
• Starter key "ON".
The conditions described below remain for 10 seconds or longer.
• Accelerator pedal opening = 0% (pedal not depressed)
• Engine coolant temperature is 71 C {159.8 F} or higher.
• The target idling speed is within the range of 745 to 755 r/min.
• Vehicle speed is 0 mile/h.
• The monitor disable DTC table can be referred to.
(2) Judgement criteria
• The fuel injection quantity is 52.5 mm
3
/st. cyl or more for 15 seconds or longer.
3. Reset condition
• Immediately after normal operation is restored.
4. Indication, warning or system control regulation when the DTC is set.
• MIL: ON
• SVS light: OFF
5. Symptoms on the vehicle when the DTC is set
<Symptoms on the vehicle due to backup control (fail safe function)>
• –
<Symptoms on the vehicle due to malfunction>
• Extremely large load applied to engine while it is idling
• Fuel injection rate abnormality
6. Pre-inspection work
• Perform diagnosis system check to confirm there is no abnormality.
• Check that the battery voltage is in the normal range.
7. After-inspection work
• Clear all past DTCs.
• Check that no DTC is stored after test drive.
8. Estimated failure factors
• Injector injection rate abnormality
• Dragging/interference with transmission
• Failure in air compressor
• Failure in power steering pump
To Next Page
Loading...
Need help?
General
