ENGINE (J05E)/TROUBLESHOOTING 2–263
INSPECTION PROCEDURE: P011C
1. Check the connection of the intake air temperature sensor (air flow
sensor) connector (looseness and poor contact).
1. Check the installation of the intake air temperature sensor (air flow
sensor).
2. Make sure there is no dirt, damage or clogging in the sensing unit
of the sensor.
1
Inspect the intake air temperature sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect the intake air temperature sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damage was found, replace the air flow
sensor.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
To Next Page
Loading...
Need help?
General
