ENGINE (J05E)/TROUBLESHOOTING2–340
INSPECTION PROCEDURE: P01A6
1. Check the connection of the common rail pressure sensor connec-
tor (looseness and poor contact).
1. Check the installation of the common rail pressure sensor.
2. Make sure there is no dirt, damage or clogging in the sensing unit
of common rail pressure sensor.
1
Inspect the common rail pressure sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect the common rail pressure sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the common rail pres-
sure sensor.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
To Next Page
Loading...
Need help?
General
