ENGINE (J05E)/TROUBLESHOOTING 2–175
1. Set the starter key to the "ON" position.
2. Select [Engine].
3. Select [NE active identification], [G active identification] in [Data
monitor and Active test].
4. Start the engine and confirm that the engine main speed sensor
(NE) and sub speed sensor (G) operate (stay ON) continuously.
1. Check if the fuel return pipe and hose are clogged.
15
Inspect the engine speed main sensor (crankshaft position sensor)
Was any failure found?
Check the faulty the engine speed main sen-
sor (crankshaft position sensor) and repair
or replace it as needed.
After inspection, go to step 16.
Go to step 16.
16
Inspect the fuel return pipe and hose
Was any failure found?
Repair or replace the faulty part. Report the TSM.
To Next Page
Loading...
Need help?
General
