EasyManuals Logo

Hino Motors HINO 195 series User Manual

Hino Motors HINO 195 series
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
ENGINE (J05E)/TROUBLESHOOTING 2–81
1. Use the electrical tester to measure the terminating resistance of
the HV ECU.
NOYES
5
Check the HV ECU (terminating resistance)
SHTS021270300064
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
HV ECU
21st – 22nd
120 10
Do the measurements meet the standard value?
Go to step 6. Replace the HV ECU.
After replacing the ECU, confirm that no CAN
communication system DTC is detected.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hino Motors HINO 195 series and is the answer not in the manual?

Hino Motors HINO 195 series Specifications

General IconGeneral
BrandHino Motors
ModelHINO 195 series
CategoryTrucks
LanguageEnglish

Related product manuals