ENGINE (J05E)/TROUBLESHOOTING 2–591
1. Use the electrical tester to measure the resistance between the
terminals of the engine ECU and oil pressure switch vehicle side
connector.
6
Inspect disconnection of the oil pressure switch harness
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Engine ECU (sig-
nal check har-
ness) – Oil
pressure switch
vehicle side con-
nector
OSW (E41) – S
Less than 1
Do the measurements meet the standard value?
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
To Next Page
Loading...
Need help?
General
