81
_____________________________________________________________________
5.3 Setting Items
______________________________________________________________
Flashing cursor
ALL
Store data for all captured waveforms.
A-B
If A cursor is in use, data is saved from the
cursor to the end of input.
If both A and B cursors are in use, data between
the cursors is saved.
Flashing cursor
(2) If using the A/B cursors on the screen, specify the
area to save.
Move the flashing cursor to the position shown in the
figure below and use the
keys to make a setting.
(3) Enter the file name to be used for Auto Save.
Once the file name has been entered, measurement data is
automatically saved as the entered name.
When multiple files are saved in succession, numbers are
appended to the file name. If the file name entry is left
blank, the file name is automatically set as "AUTO",
"AUTO0001", etc.
1. Move the flashing cursor to
File Name
and use the
buttons to display the Comment Entry Screen.
2. Move the cursor to the desired character to enter using the
buttons. For details, refer to Section 11.3.3.
To Next Page
Loading...
