Hioki 8808-51 - Page 268

244
_____________________________________________________________________
12.3 Settings on the File Screen
______________________________________________________________
Flashing cursor
Binary
The waveform data is saved in binary format.
Set
The settings are saved.
Text
The waveform data is saved in text format.
Data stored in the text format is not readable by
the product. Data of X-Y recorder in Recorder
function is not stored in the text format.
Binary (ALL)
Sequential Save data can be saved in a single
binary file. An index file is also created.
Text (ALL)
Sequential Save data can be saved in a single
text file. An index file is not created.
NOTE
An index file (with extension SEQ or RMM) is created when
measurement data is saved as a single binary file with
Sequential Save. Loading the index file loads all measurement
data saved by the corresponding Sequential Save.
When sequential save is used with instantaneous waveform
recording by the RMS recorder, "Binary ALL" and "Text ALL"
can be used for saving files.
If measurement data is saved using "Binary ALL," an index file
is created. All saved measurement data can be read at once by
reading the index file (the file with the extension SEQ and
RMM).
(2) Select the stored format.
1. Press the
START
button to display the Storing Format
Setting Screen.
2. Move the flashing cursor to the position shown in the
figure below and select the format using the
buttons.
3. Set the thinning when the text format is selected.