248
_____________________________________________________________________
12.3 Settings on the File Screen
______________________________________________________________
Flashing cursor
Select a file
to be copied
Flashing cursor
Copying File Name
1. Press the
CARD
button to display the File Screen.
2. Select the
Save
command using the buttons.
3. Select the file with the name to be copied.
4. Press the
START
button to display the setting screen for
saving format.
5. Move the flashing cursor to the File name, and press the
button twice. The file name selected in step 3 entries in the
File Name entry location.
A record of file names saved is maintained in memory.
When such record is present, you can copy file names
saved by moving the flashing cursor to the file name, then
holding down the
button. However, when the power is
cut, the record is cleared.
To Next Page
Loading...
