15
_____________________________________________________________________
2.5 Connecting the 9322 DIFFERENTIAL PROBE
______________________________________________________________
Connector guide
Grooves in the BNC
NOTE
One 9418-15 AC ADAPTER (SA145A-1240V-6, SINO
AMERICAN) is required for each 9322 to be used.
Refer to the 9322 DIFFERENTIAL PROBE Instruction Manual for
details.
3. Connect the BNC connector of the 9322 to the analog
input terminal of the product.
4. Connect the alligator clip or grabber clip to equipment to
be measured.
5. Select DC, AC or RMS output with the output selector
switch.
DC The voltage between H and L signals is divided
by 1/1000 and output as voltage relative to GND.
AC AC coupling for DC signals, and impulse voltage
is sampled on the carrier voltage.
RMS RMS conversion is applied to DC output signals
and output as a level variation.
To Next Page
Loading...
