Hioki 8808-51 - Page 90

66
_____________________________________________________________________
4.9 Numerical Calculation (Measurement)
______________________________________________________________
Flashing cursor
Flashing cursor
ALL
Perform calculations on all channels.
CH1 to CH4
Perform calculations only on the selected channels.
(3) Select the numerical calculation to perform.
Up to four simultaneous calculations (numbered 1 to 4) can
be set.
Move the flashing cursor to the items (No.1 to No.4) to be
set and select the item to be calculated using the
buttons.
(4) Select the channels for numerical calculation.
Move the flashing cursor as shown in the figure below and
set the channel using the
buttons.