QoS/Priority
120
5.1
Global
RM Web
Release
6.0
07/2010
5.1 Global
With this dialog you can:
X enter the VLAN priority for management packets in the range 0 to 7
(default setting 0).
In order for you to have full access to the management of the device, even
when there is a high network load, the device enables you to prioritize
management packets.
In prioritizing management packets (SNMP, Telnet, etc.), the device
sends the management packets with priority information.
Note the assignment of the VLAN priority to the traffic class (see table 48).
X enter the IP-DSCP value for management packets in the range 0 to 63
(default setting: 0 (be/cs0)).
In order for you to have full access to the management of the device, even
when there is a high network load, the device enables you to prioritize
management packets.
In prioritizing management packets (SNMP, Telnet, etc.), the device
sends the management packets with priority information.
Note the assignment of the IP-DSCP value to the traffic class (see
table 49).
Note: Certain DSCP values have DSCP names, such as be/cs0 to cs7
(class selector) or af11 to af43 (assured forwarding) and ef (expedited
forwarding).
X display the maximum number of queues possible per port.
The device supports 4 (8 for MACH 4000, MACH 104, MACH 1040 and
PowerMICE) priority queues (traffic classes in compliance with IEEE
802.1D).
To Next Page
Loading...
Need help?
General
