Routing
142
6.3
ARP
RM Web
Release
6.0
07/2010
6.3.4 Editing the ARP table
Deleting dynamic entries
By clicking on "Reset" you delete the dynamic entries from the ARP table.
Editing static entries
Using an assistant, you can add, edit and delete static entries.
The prerequisites for adding static entries are:
X At least one router interface is configured, is in the network of the static
entry and the routing function is switched on (see page 6.2.1).
X The router interface has at least at one port an active connection.
X The routing function is switched on globally (see on page 134 “Routing
Global“).
Click on "Wizard" to open the Wizard window.
To create a new entry, enter the IP address in the format 0.0.0.0 and
the MAC address in the format 00:00:00:00:00:00 for a new entry and
click on "Accept".
Select an entry and click on "Delete" to delete this entry.
Click on "Finished" to finish the editing and transfer the changes into
the ARP table.
Click on "Cancel" to finish the editing and reject the changes.
To Next Page
Loading...
Need help?
General
