Basic Settings
RM Web L3E
Release
6.0
07/2010
1.7
Restart
39
1.7 Restart
With this dialog you can:
X initiate a cold start of the device. The device reloads the software from the
non-volatile memory, restarts, and performs a self-test.
In your browser, click on “Reload” so that you can access the device again
after it is booted.
X initiate a warm start of the device. In this case the device checks the
software in the volatile memory and restarts. If a warm start is not
possible, a cold start is automatically performed.
X reset the entries with the status “learned” in the filter table (MAC address
table).
X reset the ARP table.
The device maintains an ARP table internally.
If, for example, you assign a new IP address to a computer and
subsequently have problems setting up a connection to the device, you
then reset the ARP table.
X reset the port counters.
X delete the log file.
Note: During the restart, the device temporarily does not transfer any data,
and it cannot be accessed via the Web-based interface or other management
systems such as HiVision.
To Next Page
Loading...
