Advanced
232
8.3
Industrial Protocols
RM Web
Release
6.0
07/2010
8.3.2 EtherNet/IP
This dialog allows you to activate the EtherNet/IP protocol. To integrate this
in a control system, perform the following steps.
General settings:
In the Switching:Multicasts:IGMP dialog, check whether IGMP
Snooping is activated (see on page 98 “IGMP (Internet Group
Management Protocol)“).
Global EtherNet/IP settings:
Activate the function in the “EtherNet/IP” frame; the default setting is off.
Click on “Download EDS File” to load the EDS file onto your PC.
Settings for the PLC:
Configure the PLC as described in the “Industry Protocols” user manual.
To Next Page
Loading...
