QoS/Priority
RM Web L3E
Release
6.0
07/2010
5.2
Port Configuration
125
5.2.4 Shaping rate
The device allows you to limit the maximum bandwidth of a port (traffic
shaping).
Click once on a cell in the “Shaping rate” column to select one of the possible
values for the bandwidth limit in the range from 5% to 95%, in steps of 5%.
The value “off” means: no bandwidth limit (0%).
The value “95” means that 95% of the bandwidth is available.
If the bandwidth set is temporarily exceeded, the device saves the data and
sends it when the bandwidth load has decreased again. Traffic Shaping thus
smooths out any overload situations.
If Traffic Shaping is active on an interface, the device ignores the bandwidths
reserved for Weighted Fair Queuing.
To Next Page
Loading...
