Diagnostics
RM Web L3E
Release
6.0
07/2010
9.8
Signal contact
259
Note: If the device is a normal ring member and not a ring manager, it
doesn't report anything for the HIPER-Ring; for the Fast HIPER-Ring
and for MRP it only reports local configuration problems.
X The elimination of the reserve redundancy for the ring/network coupling
(i.e. the redundancy function did actually switch on). Select “Monitor” for
the ring/network coupling if the signal contact is to report the elimination
of the reserve redundancy for the ring/network coupling (see on page 176
“Preparing a Ring/Network coupling“).
Default setting: no monitoring.
Note: In two-Switch coupling, both Switches must have found their
respective partners.
9.8.3 Device status
Select the tab page “Alarm 1” or “Alarm 2” (for devices with two signal
contacts).
In the “Mode Signal Contact” field, you select the “Device status” mode.
In this mode, the signal contact monitors the device status (see on
page 254 “Device Status“) and thereby offers remote diagnosis.
The device status “Error detected” (see on page 254 “Device Status“) is
reported by means of a break in the contact via the potential-free signal
contact (relay contact, closed circuit).
9.8.4 Configuring traps
Select generate Trap, if the device is to create a trap as soon as the
position of a signal contact changes when function monitoring is active.
To Next Page
Loading...
