Basic Settings
RM Web L3E
Release
6.0
07/2010
1.6
Loading/Saving the Configuration
35
If you change the current configuration (for example, by switching a port off),
the Web-based interface changes the “load/save” symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the Web-based interface displays the “load/save” symbol as a disk again.
After you have successfully saved the configuration on the device, the device
sends an alarm (trap) hmConfigurationSavedTrap together with the
information about the AutoConfiguration Adapter (ACA), if one is connected.
When you change the configuration for the first time after saving it, the device
sends a trap hmConfigurationChangedTrap.
1.6.3 URL
The URL identifies the path to the tftp server on which the configuration file
is to be stored. The URL is in the format: tftp://IP address of the tftp server/
path name/file name (e.g. tftp://192.168.1.100/device/
config.dat).
Note: The configuration file includes all configuration data, including the
passwords for accessing the device. Therefore pay attention to the access
rights on the tftp server.
1.6.4 Deleting a configuration
In the "Delete" frame, you have the option to
X Reset the current configuration to the state on delivery. The configuration
saved on the device is retained.
To Next Page
Loading...
