Routing
148
6.5
RIP
RM Web
Release
6.0
07/2010
6.5.3 Statistics
The RIP statistics window displays the numbers on counters that count
events relevant to routing.
Parameter Meaning
Source Source from which RIP takes over routing information:
– connected: The route points to a subnetwork that is connected
directly to the interface.
– static: The route is in the static routing table.
– ospf: The route is from OSPF.
Mode Use the mode to select whether RIP should take over routes from these
sources.
Metric In this column you enter the metric that RIP assigned to the routes from
the source. If the value 0 is entered, then RIP uses the value entered
under “Default Metric” (see on page 145 “General settings“)
Match
internal
Enable: Internal OSPF routes (OSPF Intra, OSPF Inter) are adopted in
RIP.
Default setting: enabled
Match
external 1
Enable: External OSPF routes of metric type 1 (OSPF Ext T1) are
adopted in RIP.
Default setting: disabled
Match
external 2
Enable: External OSPF routes of metric type 2 (OSPF Ext T2) are
adopted in RIP.
Default setting: disabled
Match NSSA
external 1
Enable: External OSPF routes of metric type 1 from an NSSA (Not so
Stubby Area) are adopted in RIP.
Default setting: disabled
Match NSSA
external 2
Enable: External OSPF routes of metric type 2 from an NSSA (Not so
Stubby Area) are adopted in RIP.
Default setting: disabled
Table 57: Route distribution table
To Next Page
Loading...
