Security
RM Web L3E
Release
6.0
07/2010
2.2
SNMPv1/v2 Access Settings
45
2.2 SNMPv1/v2 Access Settings
With this dialog you can select access via SNMPv1 or SNMPv2. In the state
on delivery, both protocols are activated.
You can thus manage the device with HiVision and communicate with earlier
versions of SNMP.
Note: To be able to read and/or change the data in this dialog, log in to the
Web-based interface with the user name “admin” and the relevant password.
X In the “Index” column, you enter the sequential number to which the
access restriction applies.
X In the “Password” column, you enter the password with which a
management station may access the device via SNMPv1/v2 from the
specified address range. Please note that passwords are case-sensitive.
X In the “IP Address” column, you enter the IP address which may access
the device. No entry in this field, or the entry “0.0.0.0”, allows access to
this device from computers with any IP address. In this case, the only
access protection is the password.
X In the “IP Mask” column, much the same as with netmasks, you have the
option of selecting a group of IP addresses.
Example:
255.255.255.255: a single IP address
255.255.255.240 with IP address = 172.168.23.20:
the IP addresses 172.168.23.16 to 172.168.23.31.
To Next Page
Loading...
Need help?
General
