Basic Settings
34
1.6
Loading/Saving the Configuration
RM Web
Release
6.0
07/2010
1.6.1 Loading the configuration
In the “Load” frame, you have the option to
X load a configuration saved on the device,
X load a configuration stored under the specified URL,
X load a configuration stored on the specified URL and save it on the
device,
X load a configuration stored on the PC as an editable and readable script
or in binary form,
If you change the current configuration (for example, by switching a port off),
the Web-based interface changes the “load/save” symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the Web-based interface displays the “load/save” symbol as a disk again.
1.6.2 Saving the Configuration
In the “Save” frame, you have the option to
X save the current configuration on the device,
X save the current configuration in binary form in a file under the specified
URL, or as an editable and readable script,
X save the current configuration in binary form or as an editable and
readable script on the PC.
Note: The loading process started by DHCP/BOOTP (see “Network“ on
page 24) shows the selection of “from URL & save local” in the “Load” frame.
If you get an error message when saving a configuration, this could be due
to an active loading process. DHCP/BOOTP only finishes a loading process
when a valid configuration has been loaded. If DHCP/BOOTP does not find
a valid configuration, finish the loading process by loading the local
configuration in the “Load” frame.
To Next Page
Loading...
