Diagnostics
RM Web L3E
Release
6.0
07/2010
9.7
Device Status
255
The events which can be selected are:
Select "Generate Trap" in the "Trap Configuration" field to activate the
sending of a trap if the device state changes.
Name Meaning
Power supply ... Monitor/ignore supply voltage(s).
Temperature Monitor/ignore temperature thresholds set (see on page 18 “System“) for
temperatures that are too high/too low
Module removal Monitor/ignore the removal of a module (for modular devices).
ACA removal Monitor/ignore the removal of the ACA.
ACA not in sync Monitor/ignore the non-matching of the configuration in the device and on
the ACA
a
a. The configurations are non-matching if only one file exists or the two files do not have the
same content.
Connection error Monitor/ignore the link status (Ok or inoperable) of at least one port.
The reporting of the link status can be masked for each port by the
management (see on page 29 “Port Configuration“). Link status is not
monitored in the state on delivery.
Ring Redundancy Monitor/ignore the redundancy failing (for the HIPER-Ring, only in ring
manager operation).
On delivery, ring redundancy is not monitored.
Note: If the device is a normal ring member and not a ring manager, it
doesn't report anything for the HIPER-Ring; for the Fast HIPER-Ring and
for MRP it only reports local configuration problems.
Ring/Network
coupling
Monitor/ignore the redundant coupling failing.
On delivery, no monitoring of the redundant coupling is set.
For two-Switch coupling with control line, the slave additionally reports
the following conditions:
– Incorrect link status of the control line
– Partner device is also a slave (in standby mode).
Note: In two-Switch coupling, both Switches must have found their
respective partners.
Fan Monitor/ignore fan function (for devices with fan).
Table 110: Device Status
To Next Page
Loading...
