Hitachi Compute Blade 500 Series - Page 17

Table 1-2 Factory default account settings for the system
administrator
Item Factory default
IP address of management module 192.168.0.1
URL of Web console https://192.168.0.1
Tip:
• The above URL indicates the default IP address of management
module, and port number is not entered since using default number.
If you changed the IP address of management module, and the port
number of web console, enter the corresponding URL for your
environment.
•
The URL is configured in the following form:
http://< IP address>:< port number> or
https://< IP address>:< port number>
• The default port number:
– http: 80
– https: 443
3. Login the Web console of the management module.
4. The following table describes the factory default account settings for the
system administrator.
Table 1-3 Factory default account settings for the system
administrator
Item Factory default
User ID administrator
Password password
5. Click the Resources tab > the target server blade from the menu tree.
Click the
Condition tab > Start Remote Console from the Server blade
Action pull down menu.
UEFI and BIOS Configuration Overview
1-3
Hitachi Compute Blade 500 Series EFI User's Guide