Hitachi Compute Blade 500 Series - Connecting to FCoE device for booting

Table 10-1 Controller configuration
Setting item Selectable value
Default
value
Contents
MultiChannel
Support
Disable
Enable
Disable MultiChannel function is Enabled
or Disabled.
Advanced
ModeSupport
Disable
Enable
Disable This item cannot be changed.
Use the default value:Disable.
Personality NIC
iSCSI
FCoE
NIC NIC: NIC only
iSCSI: NIC+iSCSI
FCoE: NIC+FCoE
4. Select Save with arrow keys, and press Enter
.
5. Press the Y key, and the system automatically reboots.
Connecting to FCoE device for booting
Setting for FCoE boot (FCoE BIOS)
This section describes the procedure to connect to FCoE boot device (FCoE
BIOS).
Fibre channel over Ethernet (FCoE)
10-3
Hitachi Compute Blade 500 Series EFI User's Guide