Starting the utility
This section describes how to start the LSI MegaRAID HITACHI SAS 3004 iMR
ROMB Configuration Utility.
1. Start the remote console, and then power on the server blade.
Click Power > Power On in the tool bar of the remote console.
2. When <F1>Setup is shown during the server blade startup, press F1.
3. UEFI setup menu starts up and the System Configuration and Boot
Management window appears.
Note: When the OS has started before pressing the key, shut down the
OS and restart the server blade. See the documents attached to your OS
for shutting down because a specific procedure may be required for
shutting down some OS, such as Windows.
4. Select System Settings on the System Configuration and Boot
Management window, and press Enter
.
5. When System Settings menu appears, select Storage and press Enter.
6. When Storage menu appears, select LSI MegaRAID HITACHI SAS
3004 iMR ROMB Configuration Utility and press Enter.
Tip: If an SMP configuration is used, a maximum of four RAID controllers
are recognized. In this case, select a target RAID controller based on the
information of [Bus xx] under [PCI Function Address:] that is displayed on
the right side of the window when you select [LSI MegaRAID <HITACHI
SAS 3004 iMR ROMB> Configuration Utility].
SAS 3004 iMR ROMB Configuration Utility
5-7
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
