Hitachi Compute Blade 500 Series - Emulex PXE BIOS Settings

Emulex PXE BIOS settings
Follow the procedure to enable the PXE boot settings.
1. Start the remote console, and then click Power > Power On to power on
a server blade.
2. When the following text is shown on the window, press Ctrl + P to go to
Emulex PXE BIOS menu.
3. Press Tab at three times to select Save, and select Continue, and then
press Enter.
4. Select Controller #* - Port #*: Bus ** Dev 00 (this port is executed
PXE boot), and press Enter
.
BIOS settings for PXE boot
8-3
Hitachi Compute Blade 500 Series EFI User's Guide