Hitachi Compute Blade 500 Series - Fast Initialization Procedure

Fast initialization procedure
This subsection describes how to execute fast initialization.
1. On Configuration Options window, select Virtual Drive Management
and press Enter.
2. Virtual Drive management window appears. Select Select Virtual Drive
Operations and press Enter.
3. Select Virtual Drive Operations window appears. Select Select Virtual
Drive and press Enter.
4. The following subwindow appears in the middle of the Select Virtual Drive
Operations window. Select a virtual drive to initialize and press Enter.
Tip: The figure above is a window when two drives are used as a single
physical drive.
5. Select Virtual Drive Operation and press Enter.
6-26
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide