Hitachi Compute Blade 500 Series - Setting Personality

Setting Personality
Setting procedure of Personality
The setting procedure of Personality is described in this section. The
personality setting makes each port of the card to be FCoE port or NIC port.
1. Start PXESelect(TM) Utility.
When the message of Press <Ctrl><P> for PXESelect(TM) Utility is
displayed in the following window during the server blade booting
process, press Ctrl and P
key simultaneously.
2. Select a controller in Controller Selection Menu with arrow keys, ↓and ↑,
and press Enter.
Tip: The Bus/Dev number of the controller changes by the number of the
I/O device on the server blade.
3. Select Personality with Tab and FCoE with arrow keys, ↓
and ↑. press
Enter.
10-2
Fibre channel over Ethernet (FCoE)
Hitachi Compute Blade 500 Series EFI User's Guide