Hitachi Compute Blade 500 Series - Data Device Setting

12. You can confirm the LU at following window when iSCSI Boot device is
correctly set to iSCSI Target.
Data device setting
1. Select iSCSI Target Configuration in the Controller Configuration
setting menu and press Enter.
2. When the iSCSI Target Configuration setting menu is displayed, select
Add New iSCSI Target and press Enter.
3. When the Add/Ping iSCSI Target setting menu is displayed, enter
iSCSI Target IP Address of iSCSI Target device to be connected. After
that, select Save/Login and press Enter
.
9-12
iSCSI settings
Hitachi Compute Blade 500 Series EFI User's Guide