Hitachi Compute Blade 500 Series - Iscsi Controller Setting

iSCSI Controller setting
Select the controller and modify the settings.
1. Select Controller Configuration by Tab in the iSCSI Initiator
Configuration
setting menu and press Enter.
2. When the Controller Selection Menu setting menu is displayed, select
controller name to be modified and press Enter.
Tip:
• All the name of available controllers are displayed on setting menu.
•
The location of the controller (Bus/Dev) is variable with the I/O
devices on the server blade. Confirm the I/O devices on the server
blade to select the controller.
3. The Controller Configuration setting menu is displayed. iSCSI Initiator
and Target are set by selecting options from this menu. When the
Controller Configuration setting menu is displayed, select Controller
Properties and press Enter.
4. When the Controller Properties setting menu is displayed, confirm that
Boot Support
is Enabled. After that, select Save by Tab and press
Enter.
iSCSI settings
9-7
Hitachi Compute Blade 500 Series EFI User's Guide