The numbers with lead line in the figure above correspond to the following
bullets.
1. Basic information
Checks and sets the hardware basic information of the disk array
controller.
For the details, see Basic information on page 7-6.
2. RAID Properties
Creates a disk array.
For the details, see
Creating disk arrays on page 7-15.
3. SAS Topology
Views, formats, and verifies information of the disk array topology.
For the details, see Checking topology information of disk array on page
7-9.
4. Advanced Adapter properties
Views the hardware information of the disk array controller.
Note:
•
Do not change the setting of "Format" and "Verify" in Advanced Adapter
properties
, because these settings are not supported
• Do not change the setting of Advanced Adapter properties, because
this setting is not supported.
• Do not use other key functions unless instructed otherwise.
Basic information
Checking and configuring disk array hardware basic information
This section describes how to check and set the hardware basic information
about the disk array controller.
7-6
SAS configuration utility
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
