Hitachi Compute Blade 500 Series - Iscsi Initiator Name Setting

iSCSI Initiator name setting
The name of iSCSI initiator must be unique identifier among other initiators
on network.
Follow the procedure to set iSCSI Initiator name.
1. Select iSCSI Initiator Name by Tab
in the iSCSI Initiator
Configuration setting menu and press Enter. After that, enter the iSCSI
Initiator name.
Tip: Factory default of iSCSI Initiator name is set to "iqn.
1990-07.com.emulex:xx-xx-xx-xx-xx-xx". "xx-xx-xx-xx-xx-xx" shows
MAC address.
2. Select Save by
Tab and press Enter to save modification.
Tip: Single name of iSCSI initiator must be specified and shared among
several NICs on a server blade. Installed several NICs on a server blade,
which the name of iSCSI initiator is already set to, may cause name
mismatch and display an error message. In this case, resetting the name
of iSCSI initiator using iSCSISelect Utility will avoid this mismatch.
9-6
iSCSI settings
Hitachi Compute Blade 500 Series EFI User's Guide