Table 4-12 Disk property menu
Menu items Description
Connector Connector of the connected disk array controller board
Enclosure ID ID number of the connected enclosure device
Mode name Disk mode name
Vendor Vendor name
Revision Firmware version
Slot Number Number of the slot installed
Device Type Device type
Connected Port Port number of the connected disk array controller board
Media Errors Number of detected media errors
Pred Fail Count Number of reported S.M.R.T warnings
SAS Address SAS address
Physical Drive State Status
Certified Certification
FDE Capable With or without encryption function
Max Device Speed Maximum speed at which a physical disk can operate
Link Speed Link speed of an interface
Temperature (Celsius) Disk temperature
Commissioned Hotspare Fault tolerance by Hotspare
Tip:
• Items described in the table above cannot be changed.
•
For hard disk status, see
Status on page 4-91.
• Media Errors and Pred Fail Count information is cleared when the
system unit is powered off.
Switching display modes
This section describes switching disk array display modes in the main menu.
There are two types of display mode: Logical View
and Physical View.
The Logical View
mode displays a list of disk array configurations that are
already set.
The Physical View mode displays a list of physical disks comprising a disk
array configuration.
4-26
MegaRAID WebBIOS for storage expansion blades
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
