Deleting virtual drives
This subsection describes how to delete virtual drives already configured.
You can use two types for deleting virtual drives. See To delete all virtual
drives on page 6-38 and To delete virtual drives respectively on page 6-38
for details.
Note: When a logical drive is deleted, the logical drive cannot work because
the logical drive information is lost. Make sure to back up necessary data
before deleting virtual drives.
Note: When initializing, executing, or rebuilding a logical drive, or executing
consistency check on it, you cannot delete the logical drive. Complete each
processing before deleting the logical drive.
To delete all virtual drives
This subsection describes how to delete all virtual drives simultaneously.
1. On Configuration Options window, select Controller Management and
press Enter.
2. Controller Management window appears. Select Clear Configuration and
press Enter.
3
. Controller Management > Warning message appears. Select Yes and
press Enter.
Tip: When you select No, those virtual drives are not deleted and the
window returns to Controller Management.
4. Controller Management > Success message appears . With OK selected,
press Enter.
5. All virtual drives are deleted. Then, Controller Options window appears.
To delete virtual drives respectively
This subsection describes how to delete a specific virtual drive.
1. On Configuration Options window, select Virtual Drive Management
and press Enter.
2. Virtual Drive Management window appears. Select Select Virtual Drive
Operations and press Enter.
3. Select Virtual Drive Operations window appears. Select Select Virtual
Drive and press Enter.
6-38
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
