Hitachi Compute Blade 500 Series - Status; Virtual Drive Status; Physical Drive Status

3. Mount Driver & Utility CD on any directory. In the following steps, Driver
& Utility CD is mounted on /media/cdrom
4. Execute the following command to perform the LSI Software RAID setting
script.
5. The following message appears and RAID setting with LSI Software RAID
is executed. Wait for command prompt.
6. Since virtual drive setting with LSI Software RAID is complete, umount
Driver & Utility CD and remove the CD.
Status
This section virtual drives and hard physical drives.
Virtual drive status
The following table shows virtual drive status.
State Description
Optimal Normal: The virtual drive fully works.
Degraded A physical drive fails in virtual drives of RAID 1.
Offline Virtual drives cannot work because multiple physical drives fails in virtual
drives with redundancy or a physical drive fails in virtual drive without
redundancy.
Physical drive status
The following table shows physical drive status.
State Description
Online Normal
Offline / Failed Some failure has occurred.
Disconnected from the virtual drive due to failure.
Rebuilding In rebuilding
Unconfigured Good Not configured into a virtual drive.
6-56
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide