3. When the following is displayed, press Esc to close the Critical Message
window.
4. When the following is displayed, press Y to exit the setup utility.
5. press F1.
Check that "<Enter> Key pressed. Preparing to boot normally Pressed.
Entering Setup" or "<F1> Setup Pressed. Entering Setup" is displayed.
6. EFI setup menu starts up.
See Starting the utility on page 5-7 to start the LSI MegaRAID HITACHI
SAS 3004 iMR ROMB Configuration Utility
5-6
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
