Hitachi Compute Blade 500 Series - Page 313

When an error message appears, follow the steps below.
Note: If your condition is one of the following, change Boot Error Handling
setting to
Ignore Errors. See
Displaying error messages at the system boot
on page 5-46 for details.
•
To prevent error messages from appearing at the system boot
• The disk array controller is no longer used.
1. When an error message appears at the system boot, press Esc.
2. See Error messages at the system boot on page 5-53 to perform
necessary measures.
Note: Boot procedure cannot proceed depending on the error message. See
Error messages at the system boot on page 5-53 for errors by which boot
procedure cannot proceed, and consult your reseller or call maintenance
personnel.
Booting with an error message
If you proceed with booting the utility with an error message on the window,
follow the steps below.
1. Press Enter when an error message is displayed.
2. When the following is displayed, type a character string such as failure or
trouble and then Press Enter.
Tip: If the Critical Message window does not appear, see Error messages
at the system boot on page 5-53 for errors by which boot procedure
cannot proceed.
SAS 3004 iMR ROMB Configuration Utility
5-5
Hitachi Compute Blade 500 Series EFI User's Guide