Hitachi Compute Blade 500 Series - Page 335

Note:
• Use Both as Select Interface Type and as Logical Sector Size as they
are.
•
Select a drive type the same as that installed in the system unit. The
default value of Select Media Type is HDD. When SSD is installed in
the system unit, select SSD as Select Media Type. If not, drives
required for creating RAID will not appear on the menu.
7. Select a physical drive to create RAID configuration following description
below.
¢
To create RAID 0 or RAID 1 using two drives
Select Check All and press Enter
.
¢
To create RAID 0 on the drive in slot 0
¢
Select a physical drive recognized as Drive Port 0 – 3:01:00 and press
Space to check in the square brackets.
¢
To create RAID 0 on the drive in slot 2
¢
Select a physical drive to use and press Space to check in the square
brackets.
Note: Make sure to select a drive following the steps above. If not, the
drive may not be selected correctly.
• RAID 0 requires one to two physical drives.
•
RAID 1 requires two physical drives.
8. Select Apply Changes and press Enter
.
SAS 3004 iMR ROMB Configuration Utility
5-27
Hitachi Compute Blade 500 Series EFI User's Guide