Message Description
An enclosure was found that
contains both SAS and SATA
drives, but this controller does not
allow mixed drive types in a single
enclosure.
Correct the problem and restart
your system.
Press any key to continue or press
C to load the configuration utility.
Cause:
The disk array controller is operated by
incorrect parameters.
Action 1:
a. Enter a character, and then press the Enter
key.
The following message appears: Critical
Message handling completed. Please exit.
b. Press the ESC key.
The selection window appears.
c. Press the Y key.
System startup continues.
Action 2:
a. Press the C key, and then press the Enter
key.
b. The LSI MegaRAID <HITACHI SAS 3004
iMR ROMB> Configuration Utility restarts.
Action 3:
If this message appeared, contact your reseller
or call maintenance personnel.
A snapshot rollback is in progress
on VDs %s, controller cannot boot
until the rollback operation
completes. Press any key to enter
the configuration utility.
Cause:
The disk array controller parameter is incorrect.
Action 1:
a. Enter a character, and then press the Enter
key.
The LSI MegaRAID <HITACHI SAS 3004
iMR ROMB> Configuration Utility restarts.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cache data was lost because of an
unexpected power-off or reboot
during a write operation, but the
adapter has recovered.
This could be because of memory
problems, bad battery, or you may
not have a battery installed.
Press any key to continue or press
C to load the configuration utility.
Cause:
An invalid power-off or reboot was executed
during a write operation.
Action 1:
a. Enter a character, and then press the Enter
key.
The following message appears: Critical
Message handling completed. Please exit.
b. Press the ESC key.
The selection window appears.
c. Press the Y key.
System startup continues.
Action 2:
a. Press the C key, and then press the Enter
key.
5-54
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
