9. Virtual Drive Management > Create Configuration > Select Drives >
Success message appears. With OK
selected, press Enter.
10. The window returns to Create Configuraion. Select Save Configuration
and press Enter.
11
. Virtual Drive Management > Create Configuration > Warning message
appears. Select Yes and press Enter.
Tip: When you select No, the configuration will not saved and the window
returns to Create Configuration window.
12. Virtual Drive Management > Create Configuration > Success message
appears. With OK selected, press Enter.
13. Configuration Options window appears.
When using a drive installed in port 1 for a single drive configuration,
execute step 1 through step 12 again.
Tip: When using a drive installed in port 1 for a single drive configuration,
select Drives Target ID: 1: SATA (a drive in slot 1) SATA, xxxx.xxxx
GB, Unconfigured Good (a drive recognized as Unconfigured Good) in
step 6 for drive selection.
14. Initialize virtual drives after configuring them. See Initializing virtual
drives on page 6-25.
Note: When newly creating virtual drives, make sure to initialize those
virtual drives. If not, those virtual drives do not work properly.
6-24
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
