To re-execute Rebuild:
When re-executing Rebuild with LSI Software RAID Configuration Utility after
stopping it, follow the steps shown below.
1. Execute step 1, step 4, and step 5 shown in Rebuilding virtual drives on
page 6-43 to show Select Drive Operations window. Then, select Select
Drive
and press Enter.
2. The following subwindow appears in the middle of the Select Drive
Operations window. Select Drives Target ID: x: SATA, xxxx.xxxGB,
Offline, a physical drive recognized as Offline and press Enter.
3. Select Drive Operation and press Enter.
LSI Software RAID Configuration Utility for disk arrays
6-51
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
