Note: The LUN to be boot target must be 00.
10. Select Boot this device via WWPN, and press Enter.
11. Check the selected list status is Used, and the WWPN value is input, and
press Esc several times.
12. Press Y key to the following message. The system reboots.
13. The boot target information will be displayed in the following screen after
rebooting if the above-mentioned setup is correct.
10-8
Fibre channel over Ethernet (FCoE)
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
