Hitachi Compute Blade 500 Series - Page 56

Menu items
Selection
1
Description
Uses Option ROM not UEFI Driver. Select
this to boot the OS in Legacy mode.
Optimized Boot • <<Enable>>
• Disable
Enables or disables Optimized Boot, which
optimizes boot time by loading minimum
drivers.
Quiet Boot
• <<Enable>>
• Disable
Enables or disables Quiet Boot. If enabled,
the system summary is not displayed.
Note:
1. A value in double angle brackets, << >>, shows the default.
System Event Logs
The System Event Logs of server blade are displayed.
User Security
Select an item to display or set, and press Enter.
The following table shows description of menu items appeared in the left side
of the window.
Select an item to display or set, and press Enter.
Table 2-31 User Security menu items
Menu items Description
Set Power-On Password Sets a power-on password.
Clear Power-On Password Deletes a power-on password.
Set Admin Password Sets an administrator password.
Clear Admin Password Deletes an administrator password.
Note:
• Once a password is set, you need to enter the password when completing
the system boot or accessing Configuration/Setup menu. With
configuration of N+M, HA, or automatic bootup of OS, do not set a
password. If you do, password authentication interferes with switching
systems at failover; password authentication function interferes the
server blade startup. Thus, those processes cannot be completed
properly.
• A password must consist of 6 up to 20 any ASCII printable characters.
Save Settings
Select Save Settings and press Enter to save the new settings.
2-36
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide