Table 2-48 User Security menu items
Menu items Description
Set Power-On Password Sets a power-on password.
Clear Power-On Password Deletes a power-on password.
Set Admin Password Sets an administrator password.
Clear Admin Password Deletes an administrator password.
Note:
• Once a password is set, you need to enter the password when completing
the system boot or accessing Configuration/Setup menu. With
configuration of N+M, HA, or automatic bootup of OS, do not set a
password. If you do, password authentication interferes with switching
systems at failover; password authentication function interferes the
server blade startup. Thus, those processes cannot be completed
properly.
•
A password must consist of 6 up to 20 any ASCII printable characters.
Save Settings
Select Save Settings and press Enter to save the new settings.
Restore Settings
Select Restore Settings and press Enter
to cancel the change in settings
and to restore to the previous settings.
Load Default Settings
Select Load Default Settings and press Enter to cancel the change in
settings and to restore to the factory default settings.
Note: The following phenomena occur when a server blade carries Broadcom
1Gb 4p/8p LAN mezzanine cards. When you execute “Load Default Settings”
on CB 520H B3 EFI BIOS menu, messages below are displayed separately.
•
Invalid IP Address value!
•
Invalid TCP Port value!
Press the Enter key until messages are not displayed. For 1 port, a message
is displayed 1 or 3 times. In the case of 1Gb 4p mezzanine card, you will
need to press the enter key 4 or 12 times in total.
Exit Setup
Select Exit Setup and press Enter
to exit from the setup menu.
When the dialog to select either you want to exit setup menu or return to
setup utility appeared, press Y to exit the setup menu.
2-56
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide
To Next Page
Loading...
