Honeywell 30 Series User Manual

7
Honeywell 30 Series IP Cameras User Guide
After the scanning, all scanned devices in the same subnet and different subnet will be
displayed in the devices list.
Figure 6 Device List
Assigning a New IP Address to a Camera
The current IP address of a camera appears in the IP ADDRESS column of the devices
list. You can assign a new static IP address to the camera.
Select the target device(s) as shown in Figure 6, click and the following figure is
displayed:
Figure 7 IP Assignment
Configure IP Address Setting
• To obtain IP address, subnet mask, and default gateway settings automatically,
check DHCP.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)