Honeywell 30 Series User Manual

32
Honeywell 30 Series IP Cameras User Guide
ranging from Medium to Excellent. If you select Customized, you can enter a value
to specify the quality.
• Maximum bit rate: Select a bit rate from the drop-down list. The bit rate ranges from
1 Mbps to a maximum of 40Mbps. If you select Customized, you can enter a value to
specify the maximum bit rate.
The Maximum bit rate setting in the Fixed quality configuration can ensure a reasonable
and limited use of network bandwidth. For example, in low light conditions where a Fixed
quality setting is applied, video packet sizes can tremendously increase when noises are
produced with electrical gains.
Configuring Audio Settings
Go to Setup  Camera Setup  Audio.
Note: HC30WF5R1/HC30W25R3-12V/HC30W25R3 supports this function.
Figure 37 Audio Settings (HC30W25R3)
Figure 38 Audio Settings (HC30WF5R1/HC30W25R3-12V)
Mute: Check to disable audio transmission from the network cameras to all clients.
Microphone source: Select Internal or External from the drop-down list.
Internal microphone input gain: Select the gain of the internal audio input according to
ambient conditions. Adjust the gain from 0% (least) to 100% (most).
External microphone input gain (HC30W25R3): Select the gain of the external audio
input according to ambient conditions. Adjust the gain from 0% (least) to 100% (most).
Audio type: Select audio codec as G.711 or G.726 and the bit rate.

Honeywell 30 Series Specifications

General

Video Compression	H.264
Series	30 Series
Category	Security Camera
Night Vision	Yes
Power Source	Wired
Motion Detection	Yes
Weather Resistance	Yes
Lens	Fixed
Storage	MicroSD card (up to 128GB)